Genicom PC4 User Manual

Page 30

Advertising
background image

18

EasyCoder PC4 User’s Guide

Chapter 3 — Operation

Label Taken Sensor

The built-in Label Taken Sensor (LTS) can be enabled to hold the

printing until the previous label (or similar) has been removed from the

printer's outfeed slot. As long as the sensor detects a label, the printer

will be BUSY and cannot receive data from host.
If using the ESim protocol described in the ESim v6.XX, Programmer’s

Reference Manual, note the following:
• The LTS can be enabled/disabled manually using the switch next to

the sensor (see below) or in the ESim protocol by an O command.

• When switching between peel-off, tear-off operation and cut-off

operation, the media feed must be readjusted by means of a j com-

mand.

The Intermec InterDriver provides options for selecting the following

modes of operation without any j or O commands having to be entered

by the operator:
• Tear-off
• Peel-off with LTS enabled
• Peel-off with LTS disabled

If the printer runs out of media while printing, do not

switch off the power during reload, or data will be lost!

OFF ON

The Label Taken Sensor can be enabled (on) or disabled (off) using a manual switch
inside the peel-off mechansim.

Advertising