Genicom PC4 - Manual (Page 32)

20 EasyCoder PC4 User’s Guide
Chapter 3 — Operation
7 Route the media through the slits in the front edge guides
8 Firmly close the top cover.
9 If loading media for the first time or if changing from another type or
size of media, perform a Label Gap Sensor Adjustment as described
on page 28. Else, tap the Feed key either 4 times or until the indicator
lamp glows green.
10 If the printer did run out of media while printing, the printing will
automatically be resumed. Else, tear off excessive media by pulling it
upwards against the tear bar.
Tear off the media upwards against the tear bar.