Instructions, Using a pc – Genicom PC4 User Manual
Page 69
EasyCoder PC4 User’s Guide
57
Appendix D — Firmware Upgrading
Normal position
Firmware down-
load position
Instructions
Using a PC
1
Install the Intermec EasyCoder PC4 Config Tool in your PC.
2
Run the PC4Conf.exe program.
3
Set up the parameters for the firmware download. Use the on-line
help for instructions.
4
Start the Firmware download wizard and follow the instructions on
the screen.
Using a Memory Cartridge
1
Switch off the printer.
2
Move the switch on the side of the cartridge to the upper position.
3
Insert the cartridge.
4
Switch on the printer. The indicator lamp will start blinking during
the upgrading. Wait until the blinking stops, which takes about 40
seconds.
5
Switch off the printer and remove the memory cartridge. Put back the
cover over the memory cartridge slot.
If the cartridge is removed at an angle, the connector pins
may be bent.