Garmin GPSMAP 190-00683-00 - Manual (Page 10)

Charging the GPSMAP 378/478
Before using the GPSMAP 378/478, you might need to charge
the battery. Plug the power cable into an external power source to
charge. You can use the unit while it is charging.
To charge the unit’s battery:
1. Lift the rubber weather cap to expose the power connector
on the back of the unit. See the image on page 1 for
connector location.
2. Align the notches and push the plug into the connector until
fully seated.
3. Plug the 12-Volt adapter into an available AC outlet, or
cigarette lighter receptacle if you have a cigarette lighter
adapter. Use care when routing the cable; make sure it does
not interfere with vehicle operation. The unit begins charging
as soon as external power is applied.
TIP: Placing the unit in Charge Mode charges the unit more
quickly than when the unit is turned on, and reduces draw on the
vehicle/vessel battery.
When you turn on the GPSMAP 376C the power source indicator on
the GPS tab shows the unit is operating off battery power ( ),
that the unit is charging ( ), or that an external power source is
in use ( ).
Using Charge Mode
If you want to charge the battery when you are not using the unit,
you can put the unit into Charge Mode.
NOTE: While in Charge Mode, the GPSMAP 378/478 draws a
small amount of current from the vessel/vehicle battery. To avoid
discharging the vehicle’s battery, disconnect the external power
cable from the unit when not in use for several days.
Over time, you might notice that the lithium-ion battery in the unit
is not holding a charge any more. This is common for lithium-ion
batteries. Contact Garmin or your Garmin dealer to order a battery
pack replacement if you are experiencing charging issues.
2 GPSMAP 378/478 Owner’s Manual
g
ettIng
s
tArted
> c
hArgIng the
gPsMAP 378/478