Messages – Garmin GPSMAP 190-00683-00 User Manual

Page 137

Advertising
background image

Messages

Accuracy Alarm—the GPS accuracy has fallen outside of user-set value.
Alarm Clock—the alarm clock has sounded.
Antenna Shorted to Ground—the external GPS antenna has an electrical

connection problem. Contact Garmin Product Support.
Approaching Turn—you are nearing a turn in a route.
Arriving at Destination—you are nearing your destination.
Batteries Low—the battery needs to be recharged.
Basemap Failed Unit Needs Repair—there is an internal problem with your

unit. Contact Garmin Product Support to have the unit serviced.
Boat Is Not Moving Fast Enough to Calibrate—the boat is not moving fast

enough for the speed wheel to provide a valid speed.
Can’t Unlock Maps—no applicable unlock code for one or more maps was

found. All MapSource maps are not accessible.
Check XM Antenna—internal problem with your GXM 30 antenna. Contact

Garmin Product Support.
Database Error—internal problem with the unit. Contact your dealer or

Garmin Product Support to have the unit repaired.
Deep Water—the water is deeper than the amount set in the Deep Water

Alarm.
Detail Maps Don’t Support Routing—maps that are loaded on the data card

do not support automatic route calculation.
Distress Call—a DSC distress call was received. Take appropriate action.
Dragging Anchor—the distance set in the Anchor Drag Alarm was exceeded.

Drift Alarm—the water depth has changed by the amount entered in the Drift

Alarm setup.
Fish Alarm—a fish was detected. The unit shows an icon and beeps (if

enabled). This alarm does not show a message banner.
Flash Flood Warning—a flash flood warning was issued for the area by the

National Weather Service.
Flood Warning—a flood warning was issued for the area by the National

Weather Service.
Lost Satellite Reception—the unit is unable to receive satellite signals.
Marine Warning—a marine warning was issued by the National Weather

Service.
Memory Full—unit memory is full, no further data can be saved.
Memory (RAM) Failed Unit Needs Repair—there is an internal problem

with your unit. Contact Garmin Product Support to have the unit serviced.
Memory (ROM) Failed Unit Needs Repair—there is an internal problem

with your unit. Contact Garmin Product Support to have the unit serviced.
Near Proximity Point—you have reached the distance set for a proximity

waypoint.
NMEA Depth is Below Transducer—no keel offset value has been received

from the external sonar device.
No Diff GPS Location—RTCM is selected but the unit is not receiving DGPS

data.
No Roads Near Destination—the destination for the road route you tried to

calculate is not near any roads. Select a different destination.

GPSMAP 378/478 Owner’s Manual

129

A

PPendIX

>

M

essAges

Advertising