Garrett Metal Detectors Graphic Target Profiling 1350 - Manual (Page 27)

 Graphic Target Profiling 1350
™
6. Pinpoint the target to find its exact location. Place
the searchcoil on the ground near, but not directly
over the target’s suspected location. Then press and
hold the PINPOINT touchpad. While maintaining
contact with the ground, first scan the searchcoil left
to right then scan front to back (i.e. make an X) until
the loudest sound is produced, indicating the target
is directly beneath the center of the searchcoil.
In addition to the audio, the Upper Scale will also
indicate when you are directly over the target by
displaying the greatest signal strength, increasing
from left to right. Simultaneously, the Lower Scale
will indicate the depth (in inches) of a coin-sized
target. A target larger than a coin will indicate a
depth reading that is shallower than it actually is,
and visa versa for a target smaller than a coin. Note
that the Upper Scale will also blink the Target ID
cursor, only as a reminder, of the Target ID that was
last obtained prior to entering the Pinpoint Mode.
7. The PROFILING feature automatically activates
upon releasing the PINPOINT / PROFILING
touchpad after pinpointing the target. When the