Garrett Metal Detectors Graphic Target Profiling 1350 - Manual (Page 38)

Garrett Metal Detectors
The GTP 1350 is engineered with a battery saving
feature. If no touchpads are pressed within 30 minutes of
being turned ON, the detector automatically turns OFF in
order to minimize battery use due to accidental turn ON.
Simply press the POWER touchpad to resume hunting.
The GTP 1350 does not come with an on-board battery
recharge function.
Completely remove all batteries from the detector when
stored for extended periods.
Replace or remove batteries by following these
instructions:
1. Turn the GTP 1350 OFF by pressing the POWER
touchpad.
2. Slide the battery case back slightly from its normal
position beneath the Arm Rest. Place both thumbs
on the lower sides of the cuff with your fingers on
the front of the case. Firm pressure will then
disengage the case from below the Arm Rest and
allow it to slide backward.
3. Slip the two covers on the battery panel up and
remove them completely.
38