GE 1000 - Manual (Page 22)

Security Pro 1000 16
Unit Number
Refers to a specific light within a house code.
¾
How to set time for light control:
1. Open the cover of the panel.
2. The panel voice prompts you to Use numbered keys to enter ID. Enter your mas-
ter access code using the numbered keys.
3. The panel voice prompts you to Please select from START MENU. Press the Add
button on the START MENU.
4. The panel voice prompts you to Select from MAIN MENU. Press the Light Con-
trol button on the MAIN MENU.
5. The panel voice responds with House Code is *, press again to change or press unit
number. This is the House Code that was set by your installer. Don’t change it.
Press the Unit # button.
6. The panel responds with Unit #1 press again to change or select from control
menu. Keep pressing the Unit # button until the correct unit is selected.
7. Press the Time button on the control menu. The panel voice prompts you, On time
is **** to change press hours and minutes then press done.
8. Press the Hours and Minutes buttons to set the correct on time.
9. Press Done. Panel will announce, Off time is **** to change press hours and min-
utes then press done.
10. Press the Hours and Minutes buttons to set the correct off time.
11. Press Done. Panel will announce the unit number with the on and off times you just
programmed.
Programming
Options
The following table is a list of options you can change.
Press Add in the START MENU and follow the voice prompts to turn an option on.
Press Delete in the START MENU to turn an option off.
When entering a single digit option number (1-9), you must type a zero before the num-
ber (i.e. 01, 02,.....). All option numbers must be 2 digits.
Programming Options
Option # Add Delete
01 - Panel Beeps On Off
02 - Panel Voice On Off