GE 23200 - Manual (Page 10)

10
Programming the Handset
4. Press prog/mute button to enter ROOM MONITOR menu, ROOM MONITOR EXTENSION ? shows in
the display.
5. Use the touch tone pad to enter the handset number to be monitored, either 1, 2, or 3.
6. The receiving handset will turn on the microphone and the originating handset will turn on the
earpiece to monitor sound from the receiving handset.
NOTE: For room monitoring mode to work, the originating handset must NOT be on the cradle.
NOTE: While in room monitoring mode, the handsets will emit an alert tone approximately every
5 seconds if there is an incoming call. You may press the home button to quit room monitor and
answer the call.
NOTE: While in room monitoring mode, the originating handset can be switched to monitor by
speaker mode by pressing the speaker button once. Switch back to earpiece by pressing the home
button once.
NOTE: Press the flash/exit button on the handset to exit room monitor mode.
Handset Setup
You may program the following items:
Set Language, Handset Name, Ringer Tone, Ringer Volume, Cell Ring Tone, Cell Ring Vol,
Set Voicemail, VIP Melody, Key Tone, Area Code, Registration, Deregistration and Default Setting.
NOTE: During programming, you may press the flash/exit button at any time to exit the menu
and return to the sub-menu.
Set Language
1. Make sure the cordless handset is OFF (not in talk mode).
2. Press the prog/mute button to go to the main menu.
3. Press CID/vol orbuttons to scroll to HANDSET SETUP.
4. Press prog/mute button to confirm.
5. Press the CID/vol orbuttons to scroll to the SET LANGUAGE menu.
6. Press prog/mute button to enter the menu. SET LANGUAGE 1ENG 2FRA 3ESP shows in
the display.
7. Use the touch tone pad on the handset to select 1ENG, 2FRA, 3ESP, or use the CID/vol
 orbuttons to scroll to the desired language. “1ENG” is the default setting.
8. Press the prog/mute button to save your selection. You will hear a confirmation tone and the
selected language shows in the display.