GE 23200 - Manual (Page 7)

7
Connections & Setup
Installing the Recharge Cradle
Choose the best location to install the recharge cradle, it should be placed on a level surface such as
a desk or table top.
Installing the Handset Battery
NOTE: You must connect the handset battery before use.
1. Push down on the top of the battery compartment cover (located on the back of each handset)
and remove the cover.
2. Plug the battery pack cord into the jack inside the battery compartment.
NOTE: It is important to maintain the polarity (black and red wires) to the jack inside the
compartment. To ensure proper battery installation, the connector is keyed and can be inserted
only one way.
3. Insert the battery pack.
4. Close the battery compartment by pushing the door up until it snaps into place.
5. Place the handset in the charging cradle.
Allow handset to charge for 16 hours prior to first use. If you don’t properly charge the
handset, battery performance is compromised.
NOTE: If the battery is not properly installed in the handset, or if the battery pack is not properly
connected to the jack inside the battery compartment. “NO BATTERY” shows in the display when
the handset is placed in the charging cradle.
IMPORTANT: After you place the handset in the cradle the display shows “CHARGING...”, then,
“SEARCHING...”, then “HANDSET NEEDS REGISTRATION” alternately. Wait until the handset
charges properly, then register the handset to the base. During the registration process, keep
your handset near the base.
NOTE: This extra handset is only compatible with the RCA model 23200.
CAUTION: The extra handset must be registered before use.
BLACK WIRE
RED WIRE
BATTERY
PRESS DOWN
FIRMLY