GoVideo DHT7000 - Manual (Page 40)

34
DHT7000 Home Theater System
No sound. • Securely connect all audio cables.
• Repair or replace any damaged audio or speaker cables.
• Press MUTE button on remote control if mute icon is displayed on the TV screen.
• The system is in Pause, Slow Motion, Forward/Reverse Scan. Press PLAY on the remote control to return to
normal playback mode.
• Check speaker levels.
Severe hum or noise. • Make sure speakers and components are correctly and securely connected.
• Make sure connecting cables are away from a transformer or motor, and at least 10 feet away from a TV or
fluorescent light.
• Move your TV away from your audio components.
• The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol.
• Clean the disc.
No stereo sound during VCD/
CD playback.
• Refer to VCD/CD audio setup on page 16 and page 30.
• Check speaker connections and settings.
No surround effect during play-
back of Dolby Digital
soundtrack.
• Refer to DVD audio setup on page 15 and page 27.
• Check speaker connections and settings.
• Depending on the DVD, the output signal may not use all 5.1 channels, but rather output monaural or stereo
sound, even if the soundtrack is recorded in Dolby Digital format.
Cannot tune in radio stations. • Make sure antennas are securely connected. Adjust the antennas and connect an external antenna if necessary.
• The signal strength of the stations is too weak (when tuning in with automatic tuning). Use manual tuning.
• No stations have been preset or the preset stations have been cleared. Preset the stations.
Remote does not function. • Remove any obstacles between the remote and the system.
• Move closer to the system when operating the remote.
• Point the remote directly at the sensor on front panel of the system.
• Replace the batteries.
Disc does not play. • Make sure there is a disc in the tray.
• Turn the disc over. Make sure the playback side is facing down on the disc tray.
• The disc is skewed or warped.
• The region code on the DVD does not match the system.
• Moisture has condensed inside the system. Remove the disc and leave the system turned on for about half an
hour.
Disc does not start playing
from the beginning.
• Program Play or Repeat Play is selected. Press CLEAR to cancel these functions before playing a disc.
• Resume Play is active. Press STOP twice and then restart DVD playback.