GoVideo DHT7000 - Manual (Page 47)

41
Connections
Getting Sta
rted
Se
tu
p
Basi
c
Ope
rations
Ad
vanc
e
d
Fe
atures
He
lp
Safety/Regulatory Information
Caution To prevent fire, shock hazard, or annoying interference, use only the recom-
mended accessories.
To prevent electric shock, do not use this (polarized) plug with an extension cord, recep-
tacle, or other outlet unless the blades can be fully inserted to prevent blade exposure.
To reduce the risk of electric shock, do not remove the unit cover or back. There are no
serviceable parts inside.
Refer servicing to qualified personnel only.
WARNING: TO AVOID HAZARDOUS EXPOSURE TO INVISIBLE LASER
RADIATION, DO NOT OPEN OR REMOVE/DEFEAT LASER TRANSPORT PRO-
TECTIVE HOUSING.
CLASS 1 LASER PRODUCT This appliance is classified as a CLASS 1 LASER
PRODUCT. The CLASS 1 LASER PRODUCT MARKING is located on the rear panel.
Note to CATV System Installer This reminder is provided to call the CATV sys-
tem installer’s attention to Article 820-40 of the National Electronic Code that provides
guidelines for proper grounding and, in particular, specifies that the cable ground shall be
connected to the grounding system of the building, as close to the point of cable entry as
practical.
User/Installer Caution Your authority to operate this FCC certified equipment
could be voided if you make changes or modifications not expressly approved by the
manufacturer, who is responsible for compliance with Part 15 FCC rules.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide rea-
sonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Cuidado Para prevenir incendio, riesgo de choque, o interferencia enfadosa, use solamente los accesorios recomendados.
Para prevenir electrochoque, no use este enchufe (polarizado) con un cordón de extensión, toma de corriente, o cualquier otra
toma a menos que los dientes puedan ser completamente insertados para prevenir exposición de los dientes. Para reducir el