Gateway 9715 User Manual
User guide, Gateway 9715 server
Advertising
Table of contents
Document Outline
- Checking Out Your Gateway Server
- Setting Up Your Server
- Managing and Maintaining Your Server
- System administration
- Identifying your server
- Creating a DOS-bootable System Update Package (SUP) CD
- Baseboard Management Controller (BMC)
- Using your System Companion CD
- Preparing for system recovery
- Caring for your server
- Installing Components
- Preparing to install components
- Preventing static electricity discharge
- Opening the server case
- Removing and installing the processor air baffle
- Removing and installing the center brace
- Closing the server case
- Installing drives
- Removing and installing the control panel
- Memory
- PCI expansion cards
- Fibre channel module
- Processors
- Installing an Intel Management Module (IMM)
- Installing and removing the ROMB (RAID on Motherboard) activation key and dedicated RAID memory
- Power subsystem
- Replacing the SCSI hot-swap backplane
- Replacing the front panel I/O board
- Replacing a hot-swap fan
- Replacing the CMOS battery
- Replacing the system board
- Using the BIOS Setup Utility
- Configuring your RAID solutions
- Introduction
- Configuring your ROMB RAID solution with the RAID BIOS Console configuration utility
- Configuring your ROMB RAID solution with the RAID Web Console
- Launching the Web Console
- Troubleshooting
- Server Specifications
- BIOS Settings
- Field Replaceable Unit (FRU) Kits
- Extensible Firmware Interface (EFI) Shell
- Safety, Regulatory, and Legal Information
- Index