Grizzly G9249 - Manual (Page 14)

-12-
g9249 12" x 37" Belt drive gap Bed lathe
Inventory
the following is a description of the main compo-
nents shipped with your machine. lay the compo-
nents out to inventory them.
Note: If you can't find an item on this list, check
the mounting location on the machine or examine
the packaging materials carefully. Occasionally
we pre-install certain components for shipping
purposes.
Box 1 Inventory: (figure 3) Qty
A. 12" x 37" lathe w/3-Jaw Chuck 6",
steady rest, and Follow rest installed
(not shown) ................................................. 1
B. rubber gaskets (lathe/stand) ................... 2
c. Brackets (Center panel) ............................. 2
D. Complete Bolt Bag ..................................... 1
— hex Bolts M12-1.75 x 50 (lathe/stand) .. 6
— lock Washers 12mm (lathe/stand) ....... 6
— Flat Washers 12mm (lathe/stand) ........ 6
— hex nuts M12-1.75 (lathe/stand) .......... 6
— phillips head screws M6-1 x 10
(Center panel) ...................................... 12
— Flat Washers 6mm (Center panel) ....... 12
— hex nuts M6-1 (Center panel) ............... 6
E. Center panel ............................................... 1
f. Chip pan ..................................................... 1
G. tool Box...................................................... 1
H. American rocker type tool post ............... 1
I. oil Can ....................................................... 1
J. drill Chuck Arbor Mt#3–B16 ...................... 1
K. live Center Mt#3 ....................................... 1
L. spindle sleeve Mt#3–Mt#5 ...................... 1
M. dead Centers Mt#3 ................................... 2
N. hex Wrench set 3, 4, 5, 6, 8mm .......1 each
O. 4-Way tool post Key .................................. 1
P. drill Chuck B16 & Key ................................ 1
Q. outside Jaws for 3-Jaw Chuck .................. 3
R. standard screwdriver #2 ............................ 1
S. handles ...................................................... 2
T. Change gears 30, 32, 46t................1 each
u. open end Wrench 13/16mm ...................... 1
V. 4-Jaw Chuck 8" .......................................... 1
W. Faceplate 12" .............................................. 1
X. Chuck Keys ................................................ 2
if any nonproprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
figure 3. Box 1 inventory.
B
C
d
e
F
g h
i
J
K
l
M
n
o
p
Q
r
s t
u
V
W
X