Grizzly G9249 - Manual (Page 65)

g9249 12" x 37" Belt drive gap Bed lathe
-63-
SEcTION 8: WIRING
Electrical Safety Instructions
1. PRINTED INfORMATION. the electrical
information included in this section is current
at the time of printing. however, in the spirit
of improvement, we may make changes to
the electrical system of future machines.
study the photos and diagrams in this
section carefully. if you notice differences
between your machine and these diagrams,
call technical support at (570) 546-9663 for
assistance.
2. SHOcK HAzARD. disconnect power from
the machine before servicing electrical com-
ponents. touching electrified parts will result
in personal injury including but not limited to
severe burns, electrocution, or death.
3. GROuNDED cIRcuIT. electrocution or fire
could result if the machine is not grounded
and installed in compliance with electrical
codes. Compliance Must be verified by a
qualified electrician.
4. cIRcuIT REQuIREMENTS. you Must fol-
low the cIRcuIT REQuIREMENTS section
on Page 10. If you are unsure about the
wiring codes in your area or you plan to
connect your machine to a shared cir-
cuit, consult a qualified electrician.
5. MOTOR WIRING. the motor wiring shown
in these diagrams are current at the time of
printing, but it may not match your machine.
Always use the wiring diagram inside the
motor junction box.
6. EXPERIENcING DIffIcuLTIES. if at any
time you are experiencing difficulties under-
standing the information included in this
section, contact our technical support at
(570) 546-9663.
wiring safety
7`
N\
GY
7aVX`
GZY
Nal$<gc
L]^iZ Li
<gZZc <g
WIRE
COLOR KEY
NZaadl Na
7gdlc 7g
View these electrical pages in
color at www.grizzly.com.