Grizzly G9249 - Manual (Page 52)

-50-
g9249 12" x 37" Belt drive gap Bed lathe
figure 85. Cross and compound slide ball oilers
(7 total).
Cross slide
Ball oilers
Compound slide
Ball oilers
figure 86. saddle way ball oilers (4 total).
saddle Way
Ball oilers
figure 87. leadscrew and feed rod ball oilers (2
total).
Ball oilers
figure 88. tailstock ball oilers.
Ball oilers
Back Gear Shaft
Lubricant frequency Qty
Multi-purpose gear
grease every
40 hours
of operation one
pump
Add one pump from a grease gun to the back gear
shaft grease fitting shown in
figure 89.
figure 89. Back gear shaft grease fitting.
grease Fitting
Ball Oilers
Lubricant frequency Qty
iso 68 sAe
20W Bearing and
gear lubricant every 8 hours
of operation 1 squirt
from oil can
Wipe clean and lubricate the ball oilers shown in
figures 85–88. to insert the oil, depress the ball
with the tip of an oil can and squirt once.
NOTICE
follow reasonable lubrication practices as
outlined in this manual for your lathe. failure
to do so could lead to premature failure of
your lathe and will void the warranty.