Graco FR60 - Manual (Page 11)

FR60 Owner’s Manual 5
Getting Started
Pairing Sensors
The ANT+ ™ sensors included with
your watch are already paired. Press
MODE until training mode appears.
The and icons appear on
the FR60 screen when the sensors are
paired.
If you purchased a sensor (with
ANT+ wireless technology)
separately, you need to pair it with
your FR60.
After you pair the first time, your
FR60 automatically recognizes your
sensor each time it is activated. This
process occurs automatically when
you turn on the FR60 and only takes
a few seconds when the sensors are
activated and functioning correctly.
When paired, your FR60 only
receives data from your sensor, and
you can go near other sensors.
Paring Additional Accessories
1. Move away (10 m) from other
sensors while the FR60 is trying
to pair with your sensor for the
first time. Bring your sensor within
range (3 m) of the FR60.
2. Press MODE > SETTINGS >
SPORT .
3. Select RUN , GENERAL , or
BIKE > HEART RATE , FOOT
POD , or BIKE SENSOR > ON .
nOTE: When pairing the foot
pod, make sure rUn is selected.
4. While the FR60 scans for new
sensors, the , , and
icons blink. The icons are solid
when paired.
TiP: The accessory needs to
send data to complete the pairing
process. You need to wear the
heart rate monitor, take a step
wearing the foot pod, or pedal your
bike with the GSC 10.