Graco FR60 - Manual (Page 14)

8 FR60 Owner’s Manual
Getting Started
nOTE: The Garmin logo should
be right-side up.
4. Bring the FR60 within range (3 m)
of the heart rate monitor.
5. Press MODE to access training
mode. The heart rate icon
appears on the training page.
6. If or heart rate data does
not appear or if you have erratic
heart rate data, you may have to
tighten the strap on your chest or
warm up for 5–10 minutes. If the
problem persists, you may have to
pair the sensors. See page 5 .
nOTE: For instructions on setting
up heart rate zones, see page 14 .
Using the Foot Pod
The foot pod is on standby and ready
to send data as soon as you install it
or move it.
TiP: Before pairing, walk 4-5
steps to wake up the foot pod.
Installing the Foot Pod on
Your Shoe Laces
1. Press the tab on the lace clip. Lift
and separate the foot pod from
the lace clip.
2. Loosen your shoe laces.
3. Thread the lace clip through
two secure sections of your
shoelaces, allowing enough room
at the top to tie the shoelaces.
Lace clip
4. Tie your shoelaces securely to
keep the foot pod from shifting
during your activity.
5. Snap the foot pod into the lace
clip. The arrow on the foot pod
must be pointed toward the toe of
your shoe.