Gateway GT5448E - Manual (Page 45)

www.gateway.com
39
Replacing the memory card
reader
To replace the memory card reader:
1 Remove the side panel by following the instructions in
“Removing the side panel” on page 31 .
2 Remove the front bezel by following the instructions in
“Removing the front bezel” on page 32 .
3 If you are installing a new card reader (not replacing an
old one), remove the two drive retention screws in the
drive bay, then go to
Step 5 . For the location of the
screws, see the photo in Step 4 .
4 Remove the two drive retention screws, disconnect the
card reader’s data cable from the system board, then
slide the drive forward and out of the drive bay.
Tools
You need a Phillips screwdriver to replace the memory card reader.
Important
The color and shape of your replacement card reader’s front
cover may vary from your original card reader.
Screws
8511861.book Page 39 Monday, December 18, 2006 11:20 AM