Step 4 – Gateway GT5448E User Manual
Page 59
www.gateway.com
53
4
Open the card retention lever.
5
Remove the old expansion card. You can slightly seesaw
the card end-to-end to loosen the card, but do not bend
the card sideways.
6
Install the new card into the expansion slot. You can
slightly seesaw the card end-to-end to help insert the
card, but do not bend the card sideways.
7
If you have just replaced an expansion card, reconnect
the expansion card cables (if any) using your notes from
. If you have added a new expansion card,
connect its cables according to its user guide.
8
Replace the side panel by following the instructions in
“Replacing the side panel” on page 33
.
Caution
Do not touch the contacts on the bottom part of the expansion
card. Touching the contacts can cause electrostatic damage to the card.
Card retention lever
8511861.book Page 53 Monday, December 18, 2006 11:20 AM