Adding or replacing a hard drive, To add or replace a hard drive, Step 5 – Gateway GT5448E User Manual
Page 46
CHAPTER 4: Upgrading Your Computer
40
5
Slide the new card reader into the bay from the front
of the case.
6
Use the screws you removed previously to secure the
card reader to the bay.
7
Connect the new card reader’s data cable to the system
board.
8
Reinstall the bezel by following the instructions in
“Replacing the front bezel” on page 32
9
Reinstall the computer case’s side panel by following
the instructions in
Adding or replacing a hard
drive
To add or replace a hard drive:
1
Remove the side panel by following the instructions in
“Removing the side panel” on page 31
.
2
If you are adding a new drive, go to
. If you are
replacing an existing drive, go to the next step.
Tools
You need a Phillips screwdriver to add or replace a hard drive.
Screws
8511861.book Page 40 Monday, December 18, 2006 11:20 AM