Gateway GT5448E - Manual (Page 54)

CHAPTER 4: Upgrading Your Computer
48
3 Remove the three screws that secure the power supply
to your computer.
4 Slide the power supply away from the back of your
computer, then pull it down and remove it.
5 Install the new power supply into the case, then install
the three screws to secure the power supply to the case.
6 Reconnect the power supply cables using your notes
from
Step 2 .
7 Replace the side panel by following the instructions in
“Replacing the side panel” on page 33 .
Replacing the heat sink and
processor
To replace the heat sink and processor:
1 Remove the side panel by following the instructions in
“Removing the side panel” on page 31 .
Tools
You need a Phillips screwdriver to replace the heat sink.
Screws
8511861.book Page 48 Monday, December 18, 2006 11:20 AM