GE JV635 - Manual (Page 9)

PART QUANTITY
Metal Grease Filters 2
Mounting Screws 4
Exhaust Adaptor 1
(for 3 1 ⁄
4
″ x 10″ rect. venting)
Exhaust Adaptor Screws 2
Exhaust Adaptor 1
(for 7” round venting)
9
• If the unit is damaged in shipment, return the unit to the
store in which it was bought for repair or replacement.
• If the unit is damaged by the customer, repair or
replacement is the responsibility of the customer.
• If the unit is damaged by the installer (if other than
the customer), repair or replacement must be made
by arrangement between customer and installer.
DAMAGE—SHIPMENT/INSTALLATION
PARTS INCLUDED
Some parts are shipped in the hood behind the filters.
On some models, the bottom cover of the hood also
needs to be removed to gain access to the parts.
MOUNTING SPACE
NOTES:
• This range hood is for installation over ranges up to
36
″ wide.
• If you are going to vent your range hood to the
outside, see the “Ducting Requirements” section for
exhaust duct preparation.
66
″ or more
from the floor
to the top of
the hood
30
″ or 36″ 30 ″
min.
Bottom edge of
cabinet needs
to be 30
″ or
more from
the cooking
surface
Flat blade and Phillips
screwdrivers
Pencil
Metal snips
(in some
applications)
Electric drill Saw (saber or keyhole)
Duct tape
Pliers
Level Caulking
Tape measure
TOOLS YOU WILL NEED
1/4
″ pivoting
hex socket
Flashlight
Wire stripper
1/4
″ Nutdriver
Installation Instructions
Charcoal Filters—JV5 Series only, if recirculating
For 30
″ hood models, order Kit no. WB02X10707.
For 36
″ hood models, order Kit no. WB02X10708.
OPTIONAL ACCESSORIES
These kits can be ordered from your GE supplier.
Cord Kit—For both 30
″ and 36″ models,
order Kit no. JXHC1.