Great Dane C5 Chariot GCKH2352S - Manual (Page 15)

Operating - 13
OPERATING
4.Push ROPS into upright position.
5.Install drilled pin (B) into holes on left and right side of ROPS, and
secure in place with spring pins (A).
6.Check the ROPS bolt torque if the ROPS is loose.
Lowering ROPS
1.Park machine safely. (See Parking Safely in the SAFETY section).
2.Remove spring pin (A) from drilled pin (B) on left and right side of ROPS.
3.Remove drilled pin from left and right side of ROPS.
4.Pull ROPS rearward to lower.
5.Install drilled pins and spring pins back into hole in ROPS to secure in
place.
Adjusting Mower Deck Cutting Height
Cutting height can be adjusted from approximately 25-125 mm (1-5 in.).
Each hole adjusts the height-of-cut (HOC) in approximately 12 mm (1/2
in.) increments.
The deck can also be raised and locked in a transport position, to provide
maximum ground clearance when moving the machine from one area to
another.
1.Park machine safely. (See Parking Safely in the SAFETY section.)
2.Move the mower deck lift lever (A) to the transport position (D).
3.Position the HOC adjustment pin (C) in the proper hole for the desired
height-of-cut.
4.Pull back and hold the mower deck lift lever (A) and release the
transport position lock lever (B).
5.Allow the mower deck lift lever (A) to rest against the HOC adjustment
pin (C).
Adjusting Mower Deck Anti-Scalp Wheels
1.Park machine safely. (See Parking Safely in the SAFETY section.)
NOTE: The flattest cut can be achieved by having all anti-scalp
wheels adjusted off the ground. Check anti-scalp wheel adjustments
each time the mower deck cutting height is changed.
It is recommended that all anti-scalp wheels be kept off the ground to
minimize scuffing.
2.Inflate tires to correct pressure.
3.Adjust mower deck to desired cutting height.
CAUTION: Avoid injury! Use roll-over protection system
(ROPS) in lowered position only when low clearance
operation is necessary.
•Do not use seat belt when ROPS is in lowered position.
•Do not operate machine on slope with ROPS in folded
position.
•Raise ROPS and fasten seat belt as soon as conditions
permit.
CAUTION: Avoid injury! Rotating blades are dangerous and
can cut fingers and toes. Stop engine, lock the park brake,
and wait for blade to stop rotating before adjusting cutting
height.
CAUTION: Avoid injury! Fingers and loose clothing can get
caught in rotating parts. Do not operate machine without all
mower deck belt shields installed.