Troubleshooting – Great Dane C5 Chariot GCKH2352S User Manual

Page 46

Advertising
background image

Troubleshooting - 44

TROUBLESHOOTING

2.Slightly loosen five wheel nuts (A).

3.Lift machine with a safe lifting device.

4.Remove wheel nuts.

5.Remove wheel and tire assembly (B).

Installing Rear Drive Wheels/Tightening Hardware:

1.Install new wheel and tire assembly.

2.Install and tighten wheel nuts in numbered sequence shown for safe
wheel installation. Tighten alternately until recommended torque value is
reached.

• Tighten nuts to 100 N•m (75 lb-ft).

3.Lower machine.

Cleaning and Repairing Plastic Surfaces

Your authorized dealer has the professional materials needed to properly
remove surface scratches from any plastic surfaces, do not attempt to
paint over marks or scratches in plastic parts.

1.Wash surface with clean water and a mild liquid automotive washing
soap.

2.Dry thoroughly to avoid water spots.

Cleaning and Repairing Metal Surfaces

Cleaning:

Follow automotive practices to care for your vehicle painted metal
surfaces. Use a high-quality automotive wax regularly to maintain the
factory look of your vehicle’s painted surfaces.

Repairing Minor Scratches (surface scratch):

1.Clean area to be repaired thoroughly.

2.Use automotive polishing compound to remove surface scratches.

3.Apply wax to entire surface.

Repairing Deep Scratches (bare metal or primer showing):

1.Clean area to be repaired with rubbing alcohol or mineral spirits.

2.Use paint stick with factory-matched colors available from your
authorized dealer to fill scratches. Follow directions included on paint stick
for use and for drying.

3.Smooth out surface using an automotive polishing compound. Do not
use power buffer.

4.Apply wax to surface.

Troubleshooting

Using Troubleshooting Chart

If you are experiencing a problem that is not listed in this chart, see your
authorized dealer for service.

When you have checked all the possible causes listed and you are still
experiencing the problem, see your authorized dealer.

CAUTION: Avoid injury! The machine can fall or slip from an
unsafe lifting device or supports.

•Use a safe lifting device rated for the load to be lifted.

•Lower machine onto jack stands or other stable
supports and block wheels before servicing.

IMPORTANT: Avoid damage! Place jack stands under frame, not
under transmission or engine, when raising or supporting
machine.

IMPORTANT: Avoid damage! Improper care of machine plastic
surfaces can damage that surface:

• Do not wipe plastic surfaces when they are dry. Dry wiping will
result in minor surface scratches.

• Use a soft, clean cloth (bath towel, diaper, automotive mitt).

• Do not use abrasive materials, such as polishing compounds,
on plastic surfaces.

• Do not spray insect repellent near machine.

IMPORTANT: Avoid damage! Do not use rubbing compound on
painted surfaces.

Advertising