Great Dane C5 Chariot GCKH2352S - Manual (Page 26)

Service Engine - 24
SERVICE ENGINE
Checking Engine Oil Level
NOTE: Check oil twice a day if you run engine over 4 hours in a day.
Make sure engine is cool when checking engine oil level.
1.Park machine safely. (See Parking Safely in the SAFETY section.)
2.Allow engine to cool.
3.Remove dipstick (A). Wipe with a clean cloth.
4.Install dipstick and allow the cap to rest on the end of the tube. Do not
tighten the cap.
5.Remove dipstick and check oil level on dipstick. Oil must be between the
ADD and FULL marks.
• If oil is low, add oil to bring oil level no higher than the FULL mark on
dipstick.
• If oil level is above the FULL mark, drain to proper level.
6.Install and tighten dipstick.
Changing Engine Oil and Filter
1.Run engine to warm oil.
2.Park machine safely. (See Parking Safely in the SAFETY section).
3.Put container under drain tube.
4.Open drain valve (A) using a 10 mm socket, 1 ft extension, swivel and 3/
8 in. drive ratchet.
5.Allow oil to drain into an oil drain pan.
6.After oil drains, close drain valve.
7.Remove oil filter using an appropriate filter wrench. Turn filter
counterclockwise to remove.
8.Apply a film of clean engine oil on gasket of new filter.
9.Install filter. Turn filter clockwise until gasket makes contact with
mounting surface. Tighten 1/2 to 3/4 turn after gasket contact.
10.Clean area around the dipstick.
11.Unscrew and remove dipstick.
12.Add approximately 1.4 L (1.5 qt) of oil.
13.Install and tighten dipstick.
14.Start engine and run at slow throttle for approximately two minutes.
Check for leaks around filter and drain valve.
15.Stop engine.
16.Check oil level:
• Remove dipstick. Wipe with a clean cloth.
• Install dipstick and allow the cap to rest on the end of the tube. Do not
tighten the cap.
• Remove dipstick and check oil level on dipstick. Oil level should be
between the ADD and FULL marks. Add oil if needed.
17.Install and tighten dipstick.
CAUTION: Avoid injury! Touching hot surfaces can burn
skin. The engine, components, and fluids will be hot if the
engine has been running. Allow the engine to cool before
servicing or working near the engine and components.
IMPORTANT: Avoid damage! Failure to check the oil level
regularly could lead to serious engine problems if oil level is low:
• Check oil level before operating.
• Keep oil level between the FULL and the ADD marks.
• Check oil level when engine is stopped, level, and is cooled so
oil has had time to drain into the sump.
IMPORTANT: Avoid damage! Dirt and debris in oil may cause
damage to the engine. Clean area around opening before
removing plug or dipstick.
IMPORTANT: Avoid damage! To prevent extensive engine wear or
damage, always maintain the proper engine oil level. Never
operate the engine with the oil level below the add mark or over
the full mark.
IMPORTANT: Avoid damage! Change the oil more often if the
vehicle is used in extreme conditions:
• Extremely dusty conditions.
• Frequent slow or low-speed operation.
• Frequent short trips.
IMPORTANT: Avoid damage! To prevent extensive engine wear or
damage, always maintain the proper engine oil level. Never
operate the engine with the oil level below the add mark or over
the full mark.
MODEL Oil Capacity With Filter (Dry)
Kawasaki Engines 1.8 L (1.9 qt)
Kohler Engines 2.0 L (2.1 qt)