Genie 3630436275 - Manual (Page 9)

9 For Help, call 1-800-35-GENIE or visit www.geniecompany.com
Learn Code Button
Figure MA-2 Learn Code Button and Indicator Light
A Install two 60 Watt light bulbs (not included) into Light
Sockets (Figure MA-4):
• Rough service, 130 Volt bulbs are recommended .
B Install Lens into slots in Motor Cover .
C Install Genie Emergency Release Kit (GER-2) accessory,
if purchased .
D Installation is now complete .
Lens
1A
Snap Lens Hinges into
slots on back of Motor Cover
60 Watts
maximum
Push in
Latches
to
close Lens
Figure MA-4 Install Lens Cover and Light
Bulbs
To Erase All Remotes from Power Head Memory
A Press and hold Learn Button on Power Head for 10
seconds or until Learn Indicator Light goes out .
Memory is erased:
• Program Transmitter/Receiver again as needed .
To Replace Remote Control Battery
A FOR NON-FLASHLIGHT MODELS (Figure MA-3)
• Pop off the back of the transmitter .
– Use coin, pen, screwdriver or any similar device .
– Replace old Battery with new coin type battery .
• Replace back of remote.
B FOR FLASHLIGHT MODELS
• Pry open battery cover . (Notch built into cover .)
– Replace old Battery with new AAA battery .
• Snap shut battery cover.
Remote Control Operation
A Press Button on Remote Control . Garage door will move .
B Press Button again . Garage door will stop:
• The door automatically stops at the end of the open or
close cycle .
C Press Button again . Garage door will reverse .
1 Button Compact Remote
w/Docking Station
Figure MA-1 Genie Remote Controls
3 Button Compact Remote
w/Docking Station
To program a Homelink® or Car2U Device:
(This GDO is Homelink® and Car2U compatible)
• Follow the Homelink® or Car2U instructions in your car
owner’s manual .
i
NStall
l
iGht
b
ulbS aND
l
eNS
WARNING
Use the Wall Console included with Opener . Any other
wall console can cause the Opener to operate unexpect-
edly and the light to stop working .
Figure MA-3 Pry case open at the notch