Garland H280 - Manual (Page 7)

07/19/07 P/N 4522555 Page 7
8) Attach Pilot Assembly to Welded Bracket on Burner
• Screw the pilot assembly to the welded bracket on the burner (Part 15, Assembly
Drawing) using the included self-tapping screw (Part 16, Assembly Drawing).
• Bend the flex tube and thermocouple approximately as shown below.
The pilot assembly fits onto the welded bracket via two holes, similar to original pilot bracket
9) Install Burner and Pilot Assembly
• Insert burner into orifice. Do not screw down the burner to the oven floor yet.
• Route thermocouple through the main gas / pilot gas tube opening in air shield.
• Route the pilot gas flex tube through the front area.
• Screw burner down to the hole at the far end of the oven (Part 9, Assembly Drawing).
Routing of pilot gas flex tube through front area, thermocouple through hole in shield.