GE MULTILINK ML1200 - Manual (Page 207)

CHAPTER 12: SPANNING TREE PROTOCOL (STP) SPANNING TREE PROTOCOL (STP)
MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL 12–11
Configuring STP parameters (continued)
ML1200(stp)##
port port=1 status=enable
Successfully set the STP status for port 1
R-2S(stp)##
show stp ports
STP Port Configuration
-------------------------------------------------------------------------------
Port# Type Priority Path Cost State Des. Bridge Des. Port
-------------------------------------------------------------------------------
01 TP(10/100) 128 100 Forwarding 80:00:00:20:06:2b:e1:54 80:01
02 TP(10/100) 20 20 Forwarding 80:00:00:20:06:2b:e1:54 80:02
03 100MB Fiber 128 100 Disabled 80:00:00:20:06:2b:e1:54 80:03
04 100MB Fiber 128 100 Disabled 80:00:00:20:06:2b:e1:54 80:04
05 100MB Fiber 128 100 Disabled 80:00:00:20:06:2b:e1:54 80:05
06 100MB Fiber 128 100 Disabled 80:00:00:20:06:2b:e1:54 80:06
07 TP(10/100) 128 100 Disabled 80:00:00:20:06:2b:e1:54 80:07
ML1200(stp)##
show stp config
STP CONFIGURATION
-----------------
Spanning Tree Enabled(Global) : YES
Spanning Tree Enabled(Ports) : YES, 1,2,3,4,5,6,7
Protocol : Normal STP
Bridge ID : 80:00:00:20:06:2b:e1:54
Bridge Priority : 15535
Bridge Forward Delay : 15
Bridge Hello Time : 2
Bridge Max Age : 20
Root Port : 0
Root Path Cost : 0
Designated Root : 80:00:00:20:06:2b:e1:54
Designated Root Priority : 15535
Root Bridge Forward Delay : 15
Root Bridge Hello Time : 2
Root Bridge Max Age : 20
The age parameter is out of range as
per the IEEE 802.1d specifications.