GE MULTILINK ML1200 - Manual (Page 289)

CHAPTER 17: MISCELLANEOUS COMMANDS MISCELLANEOUS COMMANDS
MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL 17–19
The Simple Mail Transfer Protocol (SMTP) commands for e-mail are shown below. Refer to
Chapter 17 - E-mail for additional details.
• add : adds a recipient
• delete : deletes a recipient
• help smtp
• sendmail : sends e-mail
• server : sets the global SMTP server configuration
• smtp : enables/disables SMTP e-mail alert
The Simple Network Management Protocol (SNMP) commands are shown below. Refer to
Chapter 16 - SNMP for additional details.
• authentraps : enable/disables the authentication traps
• community : configures SNMP community names
• help snmp
• mgrip : adds or deletes the SNMP manager IP
• setvar : configures system name, contact, or location
• traps : adds or deletes a trap receiver
The Simple Network Time Protocol (SNTP) commands are shown below. Refer to Chapter 5 -
Network Time for additional details.
• delete : deletes the SNTP server from SNTP server database
• help sntp
• setsntp : adds SNTP server into the SNTP server database
• sntp : configures parameters for SNTP system
• sync : sets the interval for synchronization time with an NTP server
The Spanning Tree Protocol (STP) commands are shown below. Refer to Chapter 12 -
Spanning Tree Protocol (STP) for additional details.
• cost
• lll
• port
• priority
• s-ring
• stp
• timers
The user commands are shown below.
• add : adds a new user
• chlevel : changes the user access permissions
• delete : deletes an existing user
• help user
• passwd : change the user password
• tacplus
• tacserver
• useraccess