Geemarc Ampli DECT150 - Manual (Page 14)

IMPORTANT: If you connect several bases together, the handsets registered
to the additional bases will ring for a few seconds during an incoming call
even if you take the line with one of the first base handsets.
3 - HANDSET REGISTRATION
How to register a handset to a base unit:
1 - Unplug the mains adaptor from the base unit during few seconds.
2 - Replace the adaptor to the power socket.
3 - Press the
key.
4 - Press the ( ) or the ( ) key to select the icon shown on the
display. The selected icon will flash on the display, then press key; 1/1 0000
will be displayed.
5 - Enter the base unit PIN code (factory setting to 1111), then press
key.
6 - The handset is now searching for the base unit to be registered, a beep will be
heard when the handset is registered to the base.
Note: the handset supplied with the base unit is already registered to the base unit.
So it is not necessary to register this handset.
4 - HANDSET DEREGISTRATION
To deregister the current handset from the base unit follow the instructions
below:
1 - Press the
key.
2 - Press the and the keys to enter number, 1/1 0000 will be displayed.
3 - Enter the base unit PIN code (factory setting to 1111), then press key.
The handset is deregistered from the base unit and a beep will be heard when the
handset is registered to the base. If you wish to use several handsets and base units,
all handsets must be registered. Each handset you want to use must be registered
separately to the base unit. You can register up to 2 base units for one handset and
up to 4 handsets can be registered to one base unit.
14
HANDSET SETTINGS