Geemarc Ampli DECT150 - Manual (Page 23)

ADDITIONAL HANDSETS
23
1 - GENERAL SETTINGS
With the DECT standard you have the possible settings below:
- Register up to 4 handsets to one base unit.
- Register up to 2 base units to each handset.
- Make internal call handset to handset and transfer call between handsets
registered to the same base unit.
- You can increase the phone range by using 2 base units (move between the
phone coverage areas).
2 - USING SEVERAL HANDSETS
For practical applications and to make life easier, you can register several handsets
to the same base unit. You will be able to answer a call anywhere in the office or the
home at any time because all handsets will ring at the same time. You can call
another place in the office or home by calling another registered handset.
You can transfer an incoming call to another handset.
Note: only one incoming or internal call can be made at the same time.
How to use several handsets:
All handsets you wish to use in the base unit must be registered to this base unit.
To add another handset please follow instructions below for each handset:
1 - Unplug the mains adaptor from the base unit during few seconds.
2 - Replace the adaptor to the power socket.
3 - Press the
key.
4 - Press the ( ) or the ( ) key to select the icon shown on the
display. The selected icon will flash on the display, then press key.
5 - Enter the base unit PIN code (factory setting to 1111), then press key.
6 - The handset is now searching for the base unit to be registered.