GE X-9 - Manual (Page 19)

5 Menus
TASCAM X-9 Owner’s Manual
19
Program EQ Q
values 11_E Sets the Q value for the
EQ bands of the
selected program (see
“EQ Q setting” on
page 28) After pressing ENTER to
select the menu, use the dial to
select the band (
H =high,
M *=mid, L =low) and press
ENTER.
A low value of Q
nOr Normal value of Q
B high value of Q
Value changes as selection is
made. Press
ENTER to con-
firm.
Use the left menu sys-
tem for programs 1 and
3.
Use the right menu sys-
tem for programs 2 and
4.
Meter release time 12Mr Sets the meter release
time (see “Adjusting the
output volume” on
page 16). nor * Normal
SLO Slow
Can be performed on
both left and right menu
systems.
Meter peak hold
time 13MP Sets the meter peak
hold time (“Adjusting the
output volume” on
page 16) All values are in seconds
OFF
0.5
1.0
*
2.0
Can be performed on
both left and right menu
systems.
Digital out 14dI Sets whether the signal
from the digital output is
pre- or post master
fader nOr * Post-fader signal
rEc Pre-fader signal
Can be performed on
both left and right menu
systems.
Program fader
curve 15Fc Sets the fader curve as
described and shown in
“Program fader “curve””
on page 21. After pressing ENTER to
select the menu, use the dial to
select the program fader to be
set (
1 , 2 , 3 or 4 ) and press
ENTER.
Select from the following:
A1 –6 dB
nOr * –12 dB
A2 –24 dB
Press ENTER to confirm.
Can be performed on
both left and right menu
systems.
Program fader
reverse 16Fr Sets the fader direction
to reverse as described
in “Program fader direc-
tion” on page 21. After pressing ENTER to
select the menu, use the dial to
select the program fader to be
set (
1 , 2 , 3 or 4 ) and press
ENTER.
Select:
NOr * Normal
rEV Reverse
Press ENTER to confirm.
Can be performed on
both left and right menu
systems.
Sampler tempo 17St Sets the sampler play-
back pitch for either
sampler 1 or sampler 2. After pressing ENTER to
select the menu, use the dial to
select the sampler to be set
(
S1 *, or S2 ) and press
ENTER.
Use the dial to select the value
(from -
100 to 100 ) and press
ENTER to confirm.
Can be performed on
both left and right menu
systems.
When sampler data is
erased, the value is
reset to 0%.
Function
Menu
display
Meaning Available settings Notes