GE X-9 - Manual (Page 30)

30
TASCAM X-9 Owner’s Manual
10 – Specifications, etc.
I/O specifications
Audio I/O
Control I/O
Analog inputs
LINE 1 through LINE 4 RCA pin (unbalanced)
Input level –16 dBV
Input impedance 47 k
Ω
PHONO 1 through PHONO 4 RCA pin unbalanced (with additional SIGNAL GND connector)
Input level –54 dBV
Input impedance 47 k
Ω
MIC input XLR balanced (female) a
a. All XLR connectors are wired 1=ground, 2-live (hot), 3=return (cold)
Input level –55 dBV
Input impedance 2.7 k
Ω
RETURN (L, R) 1/4” jack (unbalanced)
Input level –10 dBV
Input impedance 22 k
Ω
Analog outputs
MASTER OUTPUT (BALANCED) XLR balanced (male) a
Output level + 4dBu
Output impedance 75
Ω
MASTER OUTPUT (UNALANCED) RCA pin (unbalanced)
Output level –10 dBV
Output impedance 1 k
Ω
BOOTH OUTPUT RCA pin (unbalanced)
Output level –10 dBV
Output impedance 1 k
Ω
SEND (L, R) 1/4” jack (unbalanced)
Output level –10 dBV
Output impedance 1 k
Ω
PHONES (x 2) Stereo 1/4” jack
Maximum total output level 30 mW + 30 mW
Total load impedance 32
Ω
Digital inputs
CH 1, CH 2 RCA pin, IEC60958 TYPE I or TYPE II (auto-detect)
Digital output
DIGITAL OUT RCA pin, IEC60958 TYPE II (SPDIF)
FADER STOP/START 1 through 4 3.5 mm mini-jack (high=5 V, Low (on)=0 V) Tip=PLAY, GND=READY
FOOT SW 1, FOOT SW 2 1/4” jack (for use with RC-30P)