Miele Laboratory Glassware Washer G 7883 - Manual (Page 5)

~
Take care when handling
processing chemicals (detergents,
softeners, neutralizers, etc.). These may
contain irritant or corrosive ingredients.
Do not use organic solvents as these
could cause an explosion. Wear
protective gloves and goggles. With all
chemical agents the manufacturer’s
safety conditions must be observed.
~
Do not stand, sit or lean on the
opened machine door. This could
cause the machine to tip over, resulting
in injuries and damage.
~
Do not touch the heating elements
during or directly after the end of a
program, burns could result. The
elements remain hot for some time after
the end of the program.
~
The water in the machine must not
be used as drinking water.
~
Be careful when sorting items with
sharp, pointed ends. Carefully position
these items in the machine, so that you
will not hurt yourself or create a danger
for other operators.
~
When using this machine regard the
high temperatures and be especially
careful not to scald or burn yourself.
When opening the door bypassing the
electrical lock, a danger of burning,
scalding or corrosion exists or when
using disinfection agents, the inhalation
of toxic fumes. Let baskets and inserts
cool. Empty any water from parts into
the wash cabinet.
~
If you are exposed to toxic vapors or
processing chemicals, consult the
manufacturer's material safety data
sheets for emergency procedures.
~
Always allow mobile units, modules,
inserts, and loads to cool before
removing. Be sure to empty any water
from concave items into the wash
cabinet before removing.
~
After drying open the door to allow
the items and inserts to cool.
~
Never clean the machine or near its
vicinity with a water or high pressure
hose.
~
Avoid inhaling powder products.
They can cause burning in the mouth
and throat if swallowed, and can inhibit
breathing.
~
Before servicing, disconnect the
power supply by either removing the
fuse, unplugging the unit or manually
"tripping" the circuit breaker.
~
Whenever work is conducted on the
tap water network, the water supply line
to the washer must be cleared of air.
Failure to do so can result in damage to
the water softener.
IMPORTANT SAFETY INSTRUCTIONS
5