Miller Electric UPC 838 - Manual (Page 13)

OM-202 515 Page 9
SECTION 3 − DEFINITIONS
3-1. Warning Label Definitions
Warning! Watch Out! There are
possible hazards as shown by the
symbols.
1
Cutting sparks can cause
explosion or fire.
1.1 Keep flammables away from
cutting. Do not cut near
flammables.
1.2 Cutting sparks can cause
fires. Have a fire extinguisher
nearby, and have a
watchperson ready to use it.
1.3 Do not cut on drums or any
closed containers.
2 The plasma arc can cause
injury and burns.
2.1 Turn off power before
disassembling torch.
2.2 Do not grip material near
cutting path.
2.3 Wear complete body
protection.
3 Electric shock from torch or
wiring can kill.
3.1 Wear dry insulating gloves.
Do not wear wet or damaged
gloves.
3.2 Protect yourself from electric
shock by insulating yourself
from work and ground.
3.3 Disconnect input plug or
power before working on
machine.
4 Breathing cutting fumes can
be hazardous to your health.
4.1 Keep your head out of the
fumes.
4.2 Use forced ventilation or local
exhaust to remove the fumes.
4.3 Use ventilating fan to remove
fumes.
5 Arc rays can burn eyes and
injure skin.
5.1 Wear hat and safety glasses.
Use ear protection and button
shirt collar. Use welding
helmet with correct shade of
filter. Wear complete body
protection.
6 Become trained and read the
instructions before working on
the machine or cutting.
7 Do not remove or paint over
(cover) the label.
8 Falling equipment can cause
injury and damage to unit.
9 Always lift and support unit
using both handles. Keep
angle of lifting device less
than 60 degrees.
10 Use a proper cart to move
unit.
11 Do not use one handle to lift
or support unit.
11/00
8
9
10
11