Meridian America D-ILA 1080MF1 - Manual (Page 26)

2
3 Options Menu
Menu Display
Adjusts the display duration of the menu
screen.
Setting Values: 1sec, On
Default Value: 1sec
• The menu screen display will not disappear au-
tomatically when this is set to On. Instead, press
the EXIT button to clear the menu screen.
Sleep Time
Sets the length of time after cessation of video
input before automatically switching the unit
to the standby mode
Setting Values (min): 1, 0, 0, Off
Default Value: Off
RC232C (bps)
Sets the data rate when communicating via
the RS-232C port. Ensure that this is the same
as the rate set at the device at the other end.
Setting Values: 00, 1200
Default Value: 1200
Zoom/Focus
Locks/Unlocks the power zoom/power focus
functions of the projection lens.
Setting Values: Lock, Unlock
Default Value: Unlock
Power Save
Lowers the power (brightness) of the lamp.
Setting Values: On, Off
Default Value: Off
• Lowering the brightness of the lamp (Power
Save On) will save power, but needless to say
the image will not be as bright.
• Adjustment of settings will be disabled for
about 1 minute after the setting is changed.
Wait a minute before trying to make further
adjustments.
• Altering the Power Save setting does not affect
the lamp usage time (lamp life) of the light-
source.
4 Information Menu
• Options under this menu show information
only: no settings are available.
Lamp Time
Displays the accumulated hours of usage of
the light-source lamp.
Source
Automatically identifies the input video signal
at the projector’s DVI input, and displays the
signal name (‘1080p50’ or ‘1080p60’).
• No signal name will be displayed if no signal is
present, or if the signal is not one of the above
types (‘Out of range’ will be displayed in the lat-
ter case).
NOTES:
• When the input video signal is switched, a blue
screen will appear for about 2 seconds.
• When nothing is connected to the [DVI] termi-
nal, or if there is no video signal, a ‘No Signal
DVI-D’ message will be projected.
• In the case of a video signal that cannot be used
with this unit, an ‘Out of Range’ message will
be projected.
• Video input signals that can be used with this
unit are 1080/50p and 1080/60p signals via the
DVI-D input.