Meridian America D-ILA 1080MF1 - Manual (Page 4)


• All the safety and operating instructions should
be read before the product is operated.
• The safety and operating instructions should be
retained for future reference.
• All warnings on the product and in the operat-
ing instructions should be adhered to.
• All operating instructions should be followed.
• Place the projector near a wall outlet where the
plug can be easily unplugged.
• Unplug this product from the wall outlet before
cleaning. Do not use liquid cleaners or aerosol
cleaners. Use a damp cloth for cleaning.
• Do not use attachments not recommended by
the product manufacturer, as they may be haz-
ardous.
• Do not use this product near water. Do not use
immediately after moving from a low tempera-
ture to high temperature, as this causes conden-
sation, which may result in fire, electric shock,
or other hazards.
• Do not place this product on an unstable cart,
stand, or table. The product may fall, causing
serious injury to a child or adult, and serious
damage to the product. The product should
be mounted according to the manufacturer’s
instructions, and should use a mount recom-
mended by the manufacturer.
• When the product is used on a
cart, care should be taken to avoid
quick stops, excessive force, and
uneven surfaces which may cause
the product and cart to overturn,
damaging equipment or causing
possible injury to the operator.
• Slots and openings in the cabinet are provided
for ventilation. These ensure reliable operation
of the product and protect it from overheat-
ing, and must not be blocked or covered. (The
openings should never be blocked by placing
the product on a bed, sofa, rug, or similar sur-
face. The unit should not be placed in a built-in
installation such as a bookcase or rack unless
proper ventilation is provided and the manufac-
turer’s instructions have been adhered to.) For
proper ventilation, separate the product from
other equipment which may prevent ventilation
by a distance of at least 1ft (30 cm).
• This product should be operated only with the
type of power source indicated on the label. If
you are not sure of the type of power supply to
your home, consult your product dealer or local
power company.
• This product is equipped with a three-pin plug.
This plug will fit only into an earthed (grounded)
power outlet. If you are unable to insert the
plug into the outlet, contact your electrician
to install the proper outlet. Do not defeat the
safety purpose of the grounded plug.
• Power-supply cords should be routed so that
they are not likely to be walked on or pinched
by items placed upon or against them. Pay
particular attention to cords at doors, plugs,
receptacles, and the point where they exit from
the product.
• For added protection of this product during a
lightning storm, or when it is left unattended
and unused for long periods of time, unplug it
from the wall outlet and disconnect the cable
system. This will prevent damage to the product
due to lightning and/or power line surges.
• Do not overload wall outlets, extension cords, or
power outlet receptacles on other equipment as
this can result in a risk of fire or electric shock.
• Never push objects of any kind into this product
through openings as they may touch danger-
ous voltage points or short out parts that could
result in a fire or electric shock. Never spill liquid
of any kind on the product.
• Do not attempt to service this product yourself
as opening or removing covers may expose you
to dangerous voltages and other hazards. Refer
all service to qualified service personnel.
• Unplug this product from the wall outlet and
refer service to qualified service personnel under
the following conditions: a) When the power
supply cord or plug is damaged. b) If liquid
has been spilled, or objects have fallen on the
product. c) If the product has been exposed to
rain or water. d) If the product does not operate
normally by following the operating instruc-
tions. Adjust only those controls that are cov-
ered by this Operation Manual, as an improper
adjustment of controls may result in damage
and will often require extensive work by a quali-
fied technician to restore the product to normal
operation. e) If the product has been dropped
or damaged in any way. f) When the product
exhibits a distinct change in performance - this
indicates a need for service.
• When replacement parts are required, be sure
the service technician has used replacement
parts specified by the manufacturer or with the
same characteristics as the original part. Unau-
thorized substitutions may result in fire, electric
shock, or other hazards.
• Upon completion of any service or repairs to this
product, ask the service technician to perform
safety checks to determine that the product is in
proper operating condition.
• The product should be placed more than one
foot away from heat sources such as radia-
tors, heat registers, stoves, and other products
(including amplifiers) that produce heat.
• When connecting other products such as VCR’s,
and personal computers, you should turn off
the power of this product for protection against
electric shock.
• Do not place combustibles behind the cooling
fan. For example, cloth, paper, matches, aerosol
cans or gas lighters that present special hazards
when over heated.
• Do not look into the projection lens while the
illumination lamp is turned on. Exposure of your
eyes to the strong light can result in impaired
eyesight.
• Do not look into the inside of this unit through