Multi-Tech Systems BA-Series User Manual
Multi-Tech Systems Hardware
Advertising
Table of contents
Document Outline
- Contents
- Chapter 1 - Introduction and Description
- Chapter 2 - Installation and Connection
- Chapter 3 - Software Configuration and Modem Basics
- Chapter 4 - AT Command Mode
- 4.1 Introduction
- 4.2 Summary of AT Commands
- 4.3 Result Codes
- 4.4 Dialing Commands
- 4.4.1 Dialing Action Commands
- 4.4.2 Dial Modifier Commands
- 4.4.3 Phone Number Memory Commands
- 4.4.4 Configuration and Default Storage Commands
- 4.4.5 Command Response (Result Code) Commands
- 4.4.6 Phone Line Conditioning Commands
- 4.4.7 RS-232C Interface Control Commands
- 4.4.8 Error Correction Commands
- 4.4.9 Flow Control Commands
- 4.4.10 Compression, Error Correction, Flow Control, Pass-Through and Pacing Commands
- 4.4.11 Speed Conversion Commands
- 4.4.12 Immediate Action Commands
- 4.4.13 Line Probe Commands
- Chapter 5 - S-Registers
- Chapter 6 - Callback Security and Remote Configuration
- Chapter 7 - DIP-Switch Settings
- Chapter 8 - Warranty, Service and Tech Support
- Appendixes
- Appendix A -- Upgrading Your Modem's Firmware
- Appendix B - Troubleshooting
- Appendix C - AT Command Summary
- Appendix D - V.25bis Operation
- Appendix E - MultiModemBA Cables
- Appendix F - Regulatory Information
- Index