MSI G52-S9617X1 - Manual (Page 52)

3-12
MS-9617 ATX Workstation Board
MTRR M apping Mode
This setting controls the MTRR mapping mode. To install the W inXP64, this
setting should be set to [Continuous]. Setting options: [Continuous], [Discrete].
DRAM ECC Feature Control
If all memory in the system supports ECC, enabling this will initial scrub dram and
enable system requests to dram to be checked and/or corrected. Options:
[Enabled], [Disabled].
ECC MCE Enable
This setting enables/disables the ECC MCE function. Options: [Enabled],
[Disabled].
Chip-Kill M ode Enable
This item allows you to enable/disable Chip-Kill ECC on Nodes with all x4 ECC
capable dimms. Options: [Enabled], [Disabled].
ECC Redirection
Enable Scrubber to correct errors detected in DRAM during normal CPU re-
quests (foreground scrubbing). Options: [Enabled], [Disabled].
LDT & PCI Bus Control
Press <Enter> and the following sub-menu appears:
Upstream / Downstream LDT Bus Width
These two item control the utilized widths of the HyperTransport link. Setting
options: [8 bit], [16 bit].
LDT Bus Frequency
This item specifies the maximum operating frequency of the link's transmitter
clock. Setting options: [Auto], [800 MHz], [600 MHz], [400 MHz], [200 MHz].