Moxa Technologies UC-7420/7410 - Manual (Page 26)

UC-7420/7410 User’s Manual Getting Started
2-6
Dynamic IP addresses:
By default, UC-7420/7410 is configured for “static” IP addresses. To configure one or both
LAN ports to request an IP address dynamically, replace static with dhcp and then delete the
address, network, netmask, and broadcast lines.
Default Setting for LAN1 Dynamic Setting using DHCP
iface ixp0 inet static
address
192.168.3.127
network: 192.168.3.0
netmask 255.255.255.0
broadcast 192.168.3.255
iface ixp0 inet dhcp
3. After the boot settings of the LAN interface have been modified, issue the following
command to activate the LAN settings immediately:
#/etc/init.d/networking restart