Modifying network settings over the network, Configuring the wlan via the pcmcia interface, Ieee802.11b – Moxa Technologies UC-7420/7410 User Manual
Page 27: Modifying network settings over the network -7, Configuring the wlan via the pcmcia interface -7, Ieee802.11b -7
UC-7420/7410 User’s Manual
Getting Started
2-7
NOTE
After changing the IP settings, use the networking restart command to activate the new IP
address. However, the LCM display will still show the old IP address. To update the LCM
display, you will need to reboot the UC-7420/7410.
Modifying Network Settings over the Network
IP settings can be activated over the network, but the new settings will not be saved to the flash
ROM without modifying the file /etc/network/interfaces.
For example, type the command #ifconfig ixp0 192.168.1.1 to change the IP address of
LAN1 to 192.168.1.1.
Configuring the WLAN via the PCMCIA Interface
IEEE802.11b
The following IEEE802.11b wireless modules are supported:
y
NDC NWH1010
y
Senao NL-2511CD PLUS(F200)
y
Senao NL-2511CD PLUS EXT2 MERCURY (ETSI)
y
Senao NI3-2511CD-PLUS3
y
DARK DKW11-330HP
y
DARK XI-330H
y
Planex (PCI) GW-NS11H
y
Corega CG-WLPCCL-11
To configure the WLAN for IEEE802.11b:
1. Unplug the PCMCIA Wireless LAN card first.
2. Configure the Wireless LAN card’s default IP setting profile.
(Default IP address is 192.168.5.127, netmask 255.255.255.0)
Edit network.opts with the following command to edit Wireless LAN’s default setting.
#vi /etc/pcmcia/network.opts