McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 140)

7
7-2 McDATA UltraNet Edge 3000 User Guide
Configuring a 1x1 ATM Wide Area Network
NOTE: For help on the configuration process, click the Help button on the
active dialog box or press the F1 key.
Gathering the IP
Addresses Before starting the configuration procedure in ConfigManager you
will need to gather the IP addresses for your network. The IP host
addresses and the completed UltraNet Edge Storage Router ATM WAN
Configuration Worksheet from Appendix J will be used in the
configuration process. The worksheet is referred to as the ATM WAN
Configuration Worksheet throughout the remainder of this chapter.
Figure 7-1 shows an example of a network configured with two
UltraNet Edge Storage Routers as a 1x1 ATM WAN implementation.
Figure 7-1 Sample E_port 1x1 ATM WAN with two UltraNet Edges
Using the ATM WAN Configuration Worksheet from Appendix J,
gather the IP addresses, associated subnet masks, and other criteria to
configure each X:\Product Training and
Publications\Publications\Working\McDATA_Edge_USD\Edge\32
\userguide\chapter7.fm. The worksheet can be found on the
UltraNet Edge Storage Router Technical Documentation Library CD.
You will need the following addresses:
• Ethernet Maintenance Interface IP host address
• Default Gateway IP host address for the Ethernet Maintenance
Interface
Default
Gateway 1
ATM
Switch
192.168.10.3
192.168.10.1
192.168.144.16
192.168.20.3
192.168.20.1
192.168.144.32
ATM Cloud
Fibre
Channel
Switch
UltraNet Edge
Storage Router
Node 10 UltraNet Edge
Storage Router
Node 20
Default
Gateway 2
Sb04
7
Maintenance IP
IP Management
Maintenance IP
Fibre
Channel
Switch
ATM
Switch
IP Management