McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 360)

B-14 UltraNet™ Edge Storage Router 3000 User Guide
Cables and Equipment
Cables and Equipment
The following sections list the cables, connectors, and other
equipment needed for the UltraNet Edge 3000.
McDATA-Supplied
Cables and
Equipment The cables, adapters, and other equipment listed in Table B-3 are
supplied by McDATA.
Table B-3 McDATA-Supplied Cables and Equipment
Type Description
Power cords (2) The UltraNet Edge 3000 system comes with two 7.5-foot (2.3 meters)
IEC 320 - C 13 power cords (for use in the U.S. and Canada only). The connector
on the power cord is a three-pronged plug (NEMA 5-15P).
NOTE: McDATA supplies the required power cords for some international
shipments.
Modem A Multi-Tech modem is required as part of the optional remote support kit (site
specific).
AA adapter This cable adapter is provided with the UltraNet Edge 3000 and the optional
remote support kit. It inserts into the DCE port on the back of the remote modem
for direct connection to the UltraNet Edge 3000.
(One AA adapter is needed when using a remote modem.)
See Appendix C for cable adapter information.
EE adapter This cable adapter inserts into the DTE interface on the back of the PC for direct
connection to the serial interface on the UltraNet Edge 3000.
See Appendix C for cable adapter information.
RS-232 cables
with RJ-45
connectors This cable is used when serial connectivity is needed between an UltraNet Edge
3000 and a PC or modem.
See Appendix C for cable adapter information.
Ethernet straight
through Category
5 cable This cable is used to connect theUltraNet Edge 3000 to the network via the
Ethernet Maintenance Interface.
Ethernet
crossover
Category 5 cable This cable is used to directly connect the UltraNet Edge 3000 to a PC.