McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 96)

5
5-20 McDATA UltraNet Edge 3000 User Guide
Configuring a 1x1 Ethernet Wide Area Network
Creating a Data
Path After configuring the IP circuit, you need to establish a connection
between the FC/IP interfaces by creating a data path. This procedure
will complete the configuration process.
Once you have configured the IP circuit, your screen should look like
the following example:
1. In the main window of the UltraNet ConfigManager, right-click
on the FC/IP interface (the cloud icon for Node10) in the network
map.
The Create Data Path menu is displayed.
2. Click the Create Data Paths selection. You should see “marching
ants” outlining the FC/IP interface.
3. Double-click on the destination FC/IP interface (the cloud icon
for Node20) in the network map.
NOTE: For a 2x2 configuration, right-click the FC/IP interface (the cloud icon
for Node 11), click Create Data Paths and then double-click on the
destination FC/IP interface, (the cloud icon for Node 21) to map the second
FC/IP interface.
Right-click on the cloud icon
Double-click on the
cloud icon