Mace DVR1604RW - Manual (Page 15)

DVR1604RW Digital Video Recorder
Operational Manual © 2004 Mace Security Products 15
Camera...
· Program the related settings in the menu to start Motion detection recording. See details at
Menu>System setting>Motion detection.
3. Alarm connection operation
· Connect the alarm input according to the device connection and the instructions.
· Connect the related alarm output relay on the DVR to associated alarm device. Example: lights,
beeper, etc.
· Program the associated information in the menu. See details at Menu>System setting>Alarm
setting
4. Pan-tilt control operation
· Confirm the proper connection of the pan-tilt-zoom and Communication Protocol. Set the
Camera address.
· Confirm the proper wiring connection between the PTZ and RS-485 A & B lines and DVR’ s
25-pin port’ s A & B lines.
· Set up the programming. See details at Menu>System setting>Control
· Select full screen call-up of associated P/T/Z Camera.
· Press and hold “Assistant” on the remote controller or “Fn1” on the front panel to select
· Use direction arrow keys to move and control the selections on the screen
5. Network connection operation
· Confirm correct network connections between DVR and computer
· Set the IP address, subnet mask and gateway of the computer and DVR separately. If there is no
router in the network, only the IP address is needed. If there are routers in the network, please
enter the related gateway and subnet mask.