Motorola ENTERPRISE DIGITAL ASSISTANT MC70 - Manual (Page 176)

8 - 12 MC70 Integrator Guide
EDA battery does
not charge when
Trigger Handle is
placed in a cradle. Trigger Handle is not
properly seated in the
cradle. Remove the Trigger Handle from the cradle and reinsert.
Power is not available
to the cradle. Ensure that power connections to the cradle are connected
properly.
Cannot print to
printer. Printer cable not
connected properly. Ensure cable is connected properly to the printer and
Trigger Handle.
EDA does not wake
from suspend mode
when trigger is
pressed. The trigger only wakes
the EDA from the
suspend mode if a
scanning application is
active. Press a key on the EDA to wake from the suspend mode.
Table 8-9 Troubleshooting the Trigger Handle
Problem Cause Solution