Maytag GEMINITM - Manual (Page 16)

ANTI-TIP BRACKET
LEVELING LEG
15
OVEN WINDOW(S)
TO PROTECT THE OVEN DOOR WINDOW:
1. Do not use abrasive cleaning agents such
as steel wool scouring pads or powdered
cleaners as they may scratch the glass.
2. Do not hit the glass with pots, pans, furni-
ture, toys, or other objects.
3. Do not close the oven door until the oven
racks are in place.
Scratching, hitting, jarring or stressing the glass
may weaken its structure causing an increased
risk of breakage at a later date.
LEVELING LEGS
➢ Be sure the anti-tip bracket secures one of
the rear leveling legs to the floor. This
bracket prevents the range from acciden-
tally tipping.
The range should be leveled when
installed. If the range is not level,
turn the plastic leveling legs, lo-
cated at each corner of the
range, until range is
level.
ANTI-TIP
BRACKET
LEVELING LEG
CONVENIENCE OUTLET
(
CANADIAN MODELS ONLY
)
The convenience outlet is located on the lower
left side of the backguard.
Be sure appliance cords do not rest on or near
the surface element. If the surface element is
turned on, the cord and outlet will be damaged.
The convenience outlet circuit breaker may trip
if the small appliance plugged into it exceeds
10 amps. To reset the circuit breaker, press the
switch located on the lower edge of the back-
guard.
CIRCUIT BREAKER SWITCH
CAUTION:
CAUTION:
LOWER OVEN LIGHT
(
SELECT MODELS
)
TO REPLACE OVEN LIGHT BULB:
1. When oven is cool, hold bulb cover in
place, then slide wire retainer off cover.
NOTE: Bulb cover will fall if not held in
place while removing wire retainer.
2. Remove bulb cover and light bulb.
3. Replace with a 40-watt appliance bulb.
4. Replace bulb cover and secure with wire
retainer.
5. Reconnect power to range. Reset clock.
➢ Disconnect power to range before
replacing light bulb.
➢ Use a dry potholder to prevent pos-
sible harm to hands when replacing
bulb.
➢ Be sure bulb is cool before touching
bulb.
➢ Do not touch hot bulb with a damp
cloth as this may cause the bulb to
break.
BULB COVER
WIRE
RETAINER
Care & Cleaning
, cont.
UPPER AND LOWER OVEN
LIGHTS (
SELECT MODELS
)
To assure the proper replacement bulb is
used, order bulb from Maytag Customer
Service. Call 1-800-688-8408, ask for part
number 74004458 - halogen bulb.
➢ Disconnect power to range before
replacing light bulb.
➢ Allow oven to cool before replacing
light bulb.
➢ Make sure bulb cover and bulb are
cool before touching.
TO REPLACE OVEN LIGHT BULB:
1. When oven is cool, use fingertips to grasp
edge of bulb cover. Pull out and remove.
2. Carefully remove old bulb by pulling
straight out of ceramic base.
3. To avoid damaging or decreasing the life
of the new bulb, do not touch the bulb with
bare hands or fingers. Hold with a cloth or
paper towel. Push new bulb prongs
straight into small holes of ceramic base.
4. Replace bulb cover by snapping into
place.
5. Reconnect power to the range. Reset
clock.