Marantz VS3002 - Manual (Page 10)

5
ENGLISH
NAMES AND FUNCTIONS
AC IN AC IN
OFF OFF VP VP SR SR
OUTPUT OUTPUT REMOTE REMOTE
LINK LINK
REMOTE REMOTE
CONTROL CONTROL
EXTERNAL EXTERNAL
INTERNAL INTERNAL
OUT OUT
IN IN
FLASHER FLASHER
IN IN
RS-232C RS-232C
6 5 4 3 2 1
INPUT INPUT
2 1
q w e r t i y u
REAR PANEL
q HDMI OUTPUT jacks 1 and 2
HDMI output jacks. There are two jacks,
which can be connected to the HDMI input
jacks of devices such as TVs, projectors
and amps.
w HDMI INPUT jacks 1 to 6
HDMI input jacks. There are six jacks,
which can be connected to the HDMI
output jacks of devices such as videos and
computers.
e FLASHER IN jack
This jack is for the external operation of
the unit. It is not used when using the unit
by itself.
r RS-232C jack
A control jack for custom installers.
t REMOTE CONTROL IN/OUT
jack
Connects to Marantz products that are
equipped with a REMOTE CONTROL
(RC-5) jack. Use when you want to perform
system control of the unit with the remote
controller.
y INTERNAL/EXTERNAL switch
A switch that selects the reception method
for the remote controller signal. When
using the REMOTE CONTROL jack and
FLASHER IN jack to control the unit
from an external device, set the switch
to “EXTERNAL.” When using the unit
by itself, set the switch to “INTERNAL.”
When the switch is set to “EXTERNAL,”
signals from the remote controller cannot
be received.
u REMOTE LINK switch
A switch that selects the device to which to
apply the remote link function.
When you press INPUT button 1 to 6
after setting this switch, the set device is
switched automatically to HDMI input from
other input modes.
i Power cord jack
Connect the supplied power cord to the
unit and then connect the cord to a power
outlet.
Note:
To prevent accidents, install in a position
where the power cord can be removed
from the unit. Three power cord types are
supplied. Use the type that is appropriate
for your region. (See page 1)