Marantz VS3002 - Manual (Page 13)

8
ENGLISH
CONNECTIONS
REMOTE CONTROL CONNECTION
If you connect the remote control jack of the unit to the remote control jack of another Marantz
product, you can perform remote control of the connected devices as though they were a single
system.
• When using the unit by itself, set the INTERNAL/EXTERNAL switch of the unit to
“INTERNAL.”
¶
When controlling a connected device from the unit
• Connect the REMOTE CONTROL OUT jack of the unit to the REMOTE CONTROL IN jack of
the connected device.
• At this time, set the INTERNAL/EXTERNAL switch of the unit to “INTERNAL.”
¶
When controlling the unit from a connected device
• Connect the REMOTE CONTROL IN jack of the unit to the REMOTE CONTROL OUT jack of
the connected device.
• At this time, set the INTERNAL/EXTERNAL switch of the unit to “EXTERNAL.” The remote
controller infrared receiver of the unit is disabled and you can operate the unit through the
remote controller infrared receiver of the connected device.
AC IN AC IN
OFF OFF VP VP SR SR
OUTPUT OUTPUT REMOTE REMOTE LINK LINK
REMOTE REMOTE CONTROL CONTROL
EXTERNAL EXTERNAL INTERNAL INTERNAL
OUT OUT
IN IN FLASHER FLASHER IN IN RS-232C RS-232C
6 5 4 3 2 1
INPUT INPUT
2 1
STANDBY
POWER
PAUSE PLAY
OPEN/CLOSE
STOP
ON/OFF LEVEL
+
PHONES
-
HDMI/DVI RESOLUTION
FL OFF
OUT IN
REMOTE CONTROL
When controlling a connected device from the unit (set to INTERNAL)
When controlling the unit from a connected device (set to EXTERNAL)
DVD player
CONNECTING THE POWER CORD
1. Insert the supplied power cord into the power cord jack on the rear panel of the unit.
AC IN A C IN
OFF O FF
VP V P SR S R
REMOTE R E M O TE LINK LIN
K
2. Turn on the power switch of the connected device.
3. Insert the power cord plug into an outlet.
The STANDBY indicator on the front panel lights up in red and the unit enters standby.
Notes:
• Make sure that the AC power cord is fully inserted into the power cord jack.
• Three AC power cord types are supplied.
Use the cord type that is appropriate for your country. (See page 1)
[When Using in Japan]
Use the power cord with the flat pins that are the same shape on both sides.
[When Using in the U.S. or Canada]
Use the power cord whose plug has polarity and where one pin is thicker than the other.
[When Using in Europe]
Use the power cord with the round pins.
• Do not touch the power cord with wet hands.
• When disconnecting the power cord, always make sure that you take hold of the plug.
Yanking out or bending the cord can damage it and/or cause electric shocks or a fire.